RIOP Site Information Form International GPS Service See Instructions at: ftp://igscb.jpl.nasa.gov/pub/station/general/sitelog_instr.txt 0. Form Prepared by (full name) : Oivind Ruud Date Prepared : 2007-06-08 Report Type : UPDATE If Update: Previous Site Log : riop_20061019.log Modified/Added Sections : 2, 3.3, 4.2, 11, 12, 13 1. Site Identification of the GNSS Monument Site Name : Riobamba Permanent Station Four Character ID : RIOP Monument Inscription : None IERS DOMES Number : 42006M001 CDP Number : None Monument Description : PILLAR Height of the Monument : 1 Monument Foundation : (STEEL RODS, CONCRETE BLOCK, ROOF, etc) Foundation Depth : (m) Marker Description : (CHISELLED CROSS/DIVOT/BRASS NAIL/etc) Date Installed : 1996-04-08 Geologic Characteristic : (BEDROCK/CLAY/CONGLOMERATE/GRAVEL/SAND/etc) Bedrock Type : Undisturbed alluvium Bedrock Condition : (FRESH/JOINTED/WEATHERED) Fracture Spacing : (1-10 cm/10-50 cm/50-200 cm/over 200 cm) Fault zones nearby : (YES/NO/Name of the zone) Distance/activity : (multiple lines) Additional Information : (multiple lines) : Monument is a 5/8-inch threaded stainless steel : pin cemented into a concrete pillar. Pillar : buried, 1m above ground. 2. Site Location Information City or Town : Riobamba State or Province : Chimborazo Country : Ecuador Tectonic Plate : South American Approximate Position (ITRF) X coordinate (m) : 1255144.9670 Y coordinate (m) : -6253609.4520 Z coordinate (m) : -182569.8310 Latitude (N is +) : -013902.1444 Longitude (E is +) : -0783903.9855 Elevation (m,ellips.) : 2817.1880 Additional Information : 3. GNSS Receiver Information 3.1 Receiver Type : ROGUE SNR-8000 Satellite System : GPS Serial Number : T198 Firmware Version : 3.2 Elevation Cutoff Setting : 4 Date Installed : 1996-04-08T00:00Z Date Removed : 1999-06-17T15:05Z Temperature Stabiliz. : none Additional Information : JPL firmware version 3.2 Receiver Type : ROGUE SNR-8000 Satellite System : GPS Serial Number : T198 Firmware Version : 3.2.32.8 Elevation Cutoff Setting : 4 Date Installed : 1999-06-17T15:05Z Date Removed : 2001-12-30T23:59Z Temperature Stabiliz. : none Additional Information : (multiple lines) 3.3 Receiver Type : TRIMBLE 4000SSI Satellite System : GPS Serial Number : 36100A14803 Firmware Version : 7.19b Elevation Cutoff Setting : 10 Date Installed : 2007-05-01T00:00Z Date Removed : (CCYY-MM-DDThh:mmZ) Temperature Stabiliz. : none Additional Information : (multiple lines) 3.x Receiver Type : (A20, from rcvr_ant.tab; see instructions) Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : (A5) Firmware Version : (A11) Elevation Cutoff Setting : (deg) Date Installed : (CCYY-MM-DDThh:mmZ) Date Removed : (CCYY-MM-DDThh:mmZ) Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : (multiple lines) 4. GNSS Antenna Information 4.1 Antenna Type : AOAD/M_T NONE Serial Number : 115 Antenna Reference Point : BPA Marker->ARP Up Ecc. (m) : 0.0729 Marker->ARP North Ecc(m) : 0.0000 Marker->ARP East Ecc(m) : 0.0000 Alignment from True N : 0 Antenna Radome Type : NONE Radome Serial Number : Antenna Cable Type : (vendor & type number) Antenna Cable Length : (m) Date Installed : 1996-04-08T00:00Z Date Removed : 2002-08-12T00:00Z Additional Information : Antenna is attached to a 72.949mm fixed height : tribrach. Receiver failed late 2001. 4.2 Antenna Type : TRM29659.00 NONE Serial Number : 0220075754 Antenna Reference Point : BPA Marker->ARP Up Ecc. (m) : 0.0729 Marker->ARP North Ecc(m) : 0.0000 Marker->ARP East Ecc(m) : 0.0000 Alignment from True N : 0 Antenna Radome Type : NONE Radome Serial Number : Antenna Cable Type : (vendor & type number) Antenna Cable Length : (m) Date Installed : 2007-05-01T00:00Z Date Removed : (CCYY-MM-DDThh:mmZ) Additional Information : Antenna is attached to a 72.949mm fixed height : tribrach. 4.x Antenna Type : (A20, from rcvr_ant.tab; see instructions) Serial Number : (A*, but note the first A5 is used in SINEX) Antenna Reference Point : (BPA/BCR/XXX from "antenna.gra"; see instr.) Marker->ARP Up Ecc. (m) : (F8.4) Marker->ARP North Ecc(m) : (F8.4) Marker->ARP East Ecc(m) : (F8.4) Alignment from True N : (deg; + is clockwise/east) Antenna Radome Type : (A4 from rcvr_ant.tab; see instructions) Radome Serial Number : Antenna Cable Type : (vendor & type number) Antenna Cable Length : (m) Date Installed : (CCYY-MM-DDThh:mmZ) Date Removed : (CCYY-MM-DDThh:mmZ) Additional Information : (multiple lines) 5. Surveyed Local Ties 5.x Tied Marker Name : Tied Marker Usage : (SLR/VLBI/LOCAL CONTROL/FOOTPRINT/etc) Tied Marker CDP Number : (A4) Tied Marker DOMES Number : (A9) Differential Components from GNSS Marker to the tied monument (ITRS) dx (m) : dy (m) : dz (m) : Accuracy (mm) : (mm) Survey method : (GPS CAMPAIGN/TRILATERATION/TRIANGULATION/etc) Date Measured : (CCYY-MM-DDThh:mmZ) Additional Information : (multiple lines) 6. Frequency Standard 6.1 Standard Type : INTERNAL Input Frequency : (if external) Effective Dates : 1997-03-10/CCYY-MM-DD Notes : (multiple lines) 6.x Standard Type : (INTERNAL or EXTERNAL H-MASER/CESIUM/etc) Input Frequency : (if external) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 7. Collocation Information 7.x Instrumentation Type : (GPS/GLONASS/DORIS/PRARE/SLR/VLBI/TIME/etc) Status : (PERMANENT/MOBILE) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8. Meteorological Instrumentation 8.1.1 Humidity Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : Accuracy (% rel h) : (% rel h) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.1.x Humidity Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : (sec) Accuracy (% rel h) : (% rel h) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.2.1 Pressure Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : Accuracy : (mbar) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.2.x Pressure Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : (sec) Accuracy : (hPa) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.3.1 Temp. Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : Accuracy : (deg C) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.3.x Temp. Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : (sec) Accuracy : (hPa) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.4.1 Water Vapor Radiometer : Manufacturer : Serial Number : Distance to Antenna : (m) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.4.x Water Vapor Radiometer : Manufacturer : Serial Number : Distance to Antenna : (m) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.5.1 Other Instrumentation : (multiple lines) 8.5.x Other Instrumentation : 9. Local Ongoing Conditions Possibly Affecting Computed Position 9.1.x Radio Interferences : (TV/CELL PHONE ANTENNA/RADAR/etc) Observed Degredations : (SN RATIO/DATA GAPS/etc) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Additional Information : (multiple lines) 9.2.x Multipath Sources : (METAL ROOF/DOME/VLBI ANTENNA/etc) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Additional Information : (multiple lines) 9.3.x Signal Obstructions : (TREES/BUILDLINGS/etc) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Additional Information : (multiple lines) 10. Local Episodic Effects Possibly Affecting Data Quality 10.1 Date : 2002-??-?? Event : Large explosion adjacent to site 10.x Date : (CCYY-MM-DD/CCYY-MM-DD) Event : (TREE CLEARING/CONSTRUCTION/etc) 11. On-Site, Point of Contact Agency Information Agency : Instituto Geofísico Preferred Abbreviation : IG Mailing Address : Escuela Politécnica Nacional : Casilla 1701-2759 : Quito, Ecuador Primary Contact Contact Name : Patricia Mothes Telephone (primary) : (593-2) 222-5655 Telephone (secondary) : (593-2) 2227-031 Fax : (593-2) 2567-847 E-mail : pmothes@igepn.edu.ec Secondary Contact Contact Name : Telephone (primary) : Telephone (secondary) : Fax : E-mail : Additional Information : (multiple lines) 12. Responsible Agency (if different from 11.) Agency : Jet Propulsion Laboratory Preferred Abbreviation : JPL Mailing Address : 4800 Oak Grove Drive : Pasadena, CA : USA 91109 Primary Contact Contact Name : David A. Stowers Telephone (primary) : 818-354-7055 Telephone (secondary) : Fax : 818-393-4965 E-mail : dstowers@jpl.nasa.gov Secondary Contact Contact Name : Network Engineer/UNAVCO Telephone (primary) : 303-381-7476 Telephone (secondary) : 303-381-7500 Fax : 303-381-7451 E-mail : ruud@unavco.org, andreatta@unavco.org Additional Information : Oivind Ruud (303-381-7476) or Victoria : Andreatta (303.381.7458) 13. More Information Primary Data Center : JPL (ODC-Operational Data Center) Secondary Data Center : CDDIS (GDC-Global Data Center) URL for More Information : http://facility.unavco.org/data/data.html Hardcopy on File Site Map : Y Site Diagram : Y Horizon Mask : Monument Description : Y Site Pictures : Y Additional Information : (multiple lines) Antenna Graphics with Dimensions TRM29659.00 ----- / + \ | + | +--------------------------------------------------+ <-- 0.102 TCR | | | | | | | | +-+--------------------------------------------------+-+ <-- 0.038 +-------------------+-------------+--------------------+ <-- 0.035 BCR | | =| | +------x------+ <-- 0.000 BPA=ARP <-- 0.381 --> ARP: Antenna Reference Point L1 : L1 Phase Center L2 : L2 Phase Center TCR: Top of Chokering BCR: Bottom of Chokering TGP: Top of Ground Plane BGP: Bottom of Ground Plane TPA: Top of Preamplifier BPA: Bottom of Preamplifier TOP: Top of Pole BAM: Bottom of antenna mount All dimensions are in meters.