International GPS Service CAS1 Site Information Form See Instructions at: ftp://igscb.jpl.nasa.gov/pub/station/general/sitelog_instr.txt 0. Form Prepared by (full name) : Bob Twilley Date Prepared : 2003-11-26 Report Type : UPDATE If Update: Previous Site Log : cas1_20020613.log Modified/Added Sections : 4.1 1. Site Identification of the GNSS Monument Site Name : Casey Four Character ID : CAS1 Monument Inscription : AUS100 IERS DOMES Number : 66011M001 CDP Number : not available Monument Description : (PILLAR/BRASS PLATE/STEEL MAST/etc) Height of the Monument : (m) Monument Foundation : (STEEL RODS, CONCRETE BLOCK, ROOF, etc) Foundation Depth : (m) Marker Description : (CHISELLED CROSS/DIVOT/BRASS NAIL/etc) Date Installed : 1993-12-14 Geologic Characteristic : BEDROCK Bedrock Type : METAMORPHIC Bedrock Condition : WEATHERED Fracture Spacing : (1-10 cm/11-50 cm/51-200 cm/over 200 cm) Fault zones nearby : (YES/NO/Name of the zone) Distance/activity : (multiple lines) Additional Information : (multiple lines) : ARGN (Australian Regional GPS Network) - : Permanent GPS Tracking Network 2. Site Location Information City or Town : Casey State or Province : Australian Antarctic Territory (AAT) Country : Antarctica Tectonic Plate : Antarctic Approximate Position (ITRF) X coordinate (m) : -901776.2214 (m) Y coordinate (m) : 2409383.4976 (m) Z coordinate (m) : -5816748.4875 (m) Latitude (N is +) : -661700.24 Longitude (E is +) : +1103110.92 Elevation (m,ellips.) : 22.55 (m) Additional Information : The site is located at the Australian : antarctic research station Casey in : Wilkes Land, Australian Antarctic Territory. 3. GNSS Receiver Information 3.1 Receiver Type : AOA ICS-4000Z Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : C116 Firmware Version : 1.28.1 Elevation Cutoff Setting : (deg) Date Installed : 1994-01-01T00:00Z Date Removed : 1996-01-27T00:00Z Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : (multiple lines) 3.2 Receiver Type : AOA ICS-4000Z Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : C 127 Firmware Version : 3.2.33.1 Elevation Cutoff Setting : (deg) Date Installed : 1996-01-27T02:30Z Date Removed : 1999-08-21T00:00Z Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : (multiple lines) 3.3 Receiver Type : AOA ICS-4000Z Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : C 127 Firmware Version : 3.2.33.9 Elevation Cutoff Setting : (deg) Date Installed : 1999-12-09T00:00Z Date Removed : 2000-02-05T00:00Z Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : (multiple lines) 3.4 Receiver Type : AOA ICS-4000Z ACT Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : C122U Firmware Version : 3.3.32.3 Elevation Cutoff Setting : (deg) Date Installed : 2000-02-05T00:00Z Date Removed : (CCYY-MM-DDThh:mmZ) Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : (multiple lines) 3.x Receiver Type : (A20, from rcvr_ant.tab; see instructions) Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : (A5) Firmware Version : (A11) Elevation Cutoff Setting : (deg) Date Installed : (CCYY-MM-DDThh:mmZ) Date Removed : (CCYY-MM-DDThh:mmZ) Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : (multiple lines) 4. GNSS Antenna Information 4.1 Antenna Type : AOAD/M_T Serial Number : 259 Antenna Reference Point : BPA Marker->ARP Up Ecc. (m) : 0.001 Marker->ARP North Ecc(m) : (F8.4) Marker->ARP East Ecc(m) : (F8.4) Alignment from True N : Antenna Radome Type : AUST Radome Serial Number : Antenna Cable Type : (vendor & type number) Antenna Cable Length : (m) Date Installed : 1994-01-01 Date Removed : (CCYY-MM-DDThh:mmZ) Additional Information : Dome replaced with same type - 4.x Antenna Type : (A20, from rcvr_ant.tab; see instructions) Serial Number : (A*, but note the first A5 is used in SINEX) Antenna Reference Point : (BPA/BCR/XXX from "antenna.gra"; see instr.) Marker->ARP Up Ecc. (m) : (F8.4) Marker->ARP North Ecc(m) : (F8.4) Marker->ARP East Ecc(m) : (F8.4) Alignment from True N : (deg; + is clockwise/east) Antenna Radome Type : (A4 from rcvr_ant.tab; see instructions) Radome Serial Number : Antenna Cable Type : (vendor & type number) Antenna Cable Length : (m) Date Installed : (CCYY-MM-DDThh:mmZ) Date Removed : (CCYY-MM-DDThh:mmZ) Additional Information : (multiple lines) 5. Surveyed Local Ties 5.x Tied Marker Name : Tied Marker Usage : (SLR/VLBI/LOCAL CONTROL/FOOTPRINT/etc) Tied Marker CDP Number : (A4) Tied Marker DOMES Number : (A9) Differential Components from GNSS Marker to the tied monument (ITRS) dx (m) : dy (m) : dz (m) : Accuracy (mm) : (mm) Survey method : (GPS CAMPAIGN/TRILATERATION/TRIANGULATION/etc) Date Measured : (CCYY-MM-DDThh:mmZ) Additional Information : (multiple lines) 6. Frequency Standard 6.1 Standard Type : RUBIDIUM Input Frequency : 5 MHz Effective Dates : (1994-07-11/1998-01-08) Notes : (multiple lines) 6.2 Standard Type : QUARTZ/INTERNAL Input Frequency : 5 MHz Effective Dates : 1998-01-09T02:52Z/CCYY-MM-DD Notes : 6.x Standard Type : (INTERNAL or EXTERNAL H-MASER/CESIUM/etc) Input Frequency : (if external) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 7. Collocation Information 7.x Instrumentation Type : Status : (PERMANENT/MOBILE) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8. Meteorological Instrumentation 8.1.1 Humidity Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : Accuracy (% rel h) : (% rel h) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.1.x Humidity Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : (sec) Accuracy (% rel h) : (% rel h) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.2.1 Pressure Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : Accuracy : (mbar) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.2.x Pressure Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : (sec) Accuracy : (hPa) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.3.1 Temp. Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : Accuracy : (deg C) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.3.x Temp. Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : (sec) Accuracy : (hPa) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.4.1 Water Vapor Radiometer : Manufacturer : Serial Number : Distance to Antenna : (m) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.4.x Water Vapor Radiometer : Manufacturer : Serial Number : Distance to Antenna : (m) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.5.1 Other Instrumentation : (multiple lines) 8.5.x Other Instrumentation : 9. Local Ongoing Conditions Possibly Affecting Computed Position 9.1.x Radio Interferences : (TV/CELL PHONE ANTENNA/RADAR/etc) Observed Degredations : (SN RATIO/DATA GAPS/etc) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Additional Information : (multiple lines) 9.2.x Multipath Sources : (METAL ROOF/DOME/VLBI ANTENNA/etc) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Additional Information : (multiple lines) 9.3.x Signal Obstructions : (TREES/BUILDLINGS/etc) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Additional Information : (multiple lines) 10. Local Episodic Effects Possibly Affecting Data Quality 10.x Date : (CCYY-MM-DD/CCYY-MM-DD) Event : (TREE CLEARING/CONSTRUCTION/etc) 11. On-Site, Point of Contact Agency Information Agency : Geoscience Australia : Preferred Abbreviation : (A10) Mailing Address : Geoscience Australia : P.O. Box 2 : Belconnen ACT 2616 : AUSTRALIA Primary Contact Contact Name : Bob Twilley Telephone (primary) : +61 2 62014346 Telephone (secondary) : 0413 604180 (mobile) Fax : +61 2 62014366 E-mail : bobtwilley@auslig.gov.au Secondary Contact Contact Name : Paul Digney Telephone (primary) : +61 2 62014369 Telephone (secondary) : Fax : +61 2 62014366 E-mail : pauldigney@auslig.gov.au Additional Information : (multiple lines) 12. Responsible Agency (if different from 11.) Agency : (multiple lines) Preferred Abbreviation : (A10) Mailing Address : (multiple lines) Primary Contact Contact Name : Telephone (primary) : Telephone (secondary) : Fax : E-mail : Secondary Contact Contact Name : Telephone (primary) : Telephone (secondary) : Fax : E-mail : Additional Information : (multiple lines) 13. More Information URL for More Information : Hardcopy on File Site Map : (Y or URL) Site Diagram : X Horizon Mask : X Monument Description : X Site Pictures : Y Additional Information : (multiple lines) Antenna Graphics with Dimensions TURBOROGUE: DORNE MARGOLIN T ----- / + \ <-- 0.128 L2 | + | <-- 0.110 L1 +--------------------------------------------------+ <-- 0.102 TCR | | | | | | | | +-+--------------------------------------------------+-+ <-- 0.038 +-------------------+-------------+--------------------+ <-- 0.035 BCR | | =| | +------x------+ <-- 0.000 ARP <-- 0.381 --> ARP: Antenna Reference Point L1 : L1 Phase Center L2 : L2 Phase Center TCR: Top of Chokering BCR: Bottom of Chokering