ALIC Site Information Form International GPS Service See Instructions at: ftp://igscb.jpl.nasa.gov/pub/station/general/sitelog_instr.txt 0. Form Prepared by (full name) : Bob Twilley Date Prepared : 2000-02-02 Report Type : UPDATE If Update: Previous Site Log : alic0002.log Modified/Added Sections : (n.n,n.n,...) 1. Site Identification of the GNSS Monument Site Name : Alice Springs AU012 Four Character ID : ALIC Monument Inscription : National Geodetic Fiducial Ntwk (AUSLIG) AU012 IERS DOMES Number : 50137M001 CDP Number : Not Available Monument Description : (PILLAR/BRASS PLATE/STEEL MAST/etc) Height of the Monument : (m) Monument Foundation : (STEEL RODS, CONCRETE BLOCK, ROOF, etc) Foundation Depth : (m) Marker Description : (CHISELLED CROSS/DIVOT/BRASS NAIL/etc) Date Installed : 1992-08-12 Geologic Characteristic : BEDROCK Bedrock Type : METAMORPHIC Bedrock Condition : Weathered Fracture Spacing : (1-10 cm/11-50 cm/51-200 cm/over 200 cm) Fault zones nearby : (YES/NO/Name of the zone) Distance/activity : (multiple lines) Additional Information : (multiple lines) : Monument is a 600mm dia concrete pillar, : 0.5 metes above ground surface. 2. Site Location Information City or Town : Alice Springs State or Province : Northern Territory Country : Australia Tectonic Plate : Australian Approximate Position (ITRF) X coordinate (m) : -4052051.7667 Y coordinate (m) : 4212836.2154 Z coordinate (m) : -2545106.0270 Latitude (N is +) : -234012.36 Longitude (E is +) : +1335307.80 Elevation (m,ellips.) : 603.358 Additional Information : ARGN (Australian Regional GPS Network) - 3. GNSS Receiver Information 3.1 Receiver Type : AOA ICS-4000Z Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : C128 Firmware Version : 3.2.33.1 Elevation Cutoff Setting : (deg) Date Installed : 1994-05-15 Date Removed : 1999-07-31T01:00Z Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : 3.2 Receiver Type : AOA ICS-4000Z Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : C128 Firmware Version : 3.2.32.9 Elevation Cutoff Setting : (deg) Date Installed : 1999-07-31T01:00Z Date Removed : 2000-01-14T01:50Z Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : Upgrade of firmware to avoid GPS week 3.3 Receiver Type : AOA SNR-12 ACT Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : C102U Firmware Version : 3.3.32.3 Elevation Cutoff Setting : (deg) Date Installed : 2000-01-14T02:00Z Date Removed : 2000-01-24T01:00Z Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : This receiver is AC power only 3.4 Receiver Type : AOA ICS-4000Z ACT Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : C126U Firmware Version : 3.3.32.3 Elevation Cutoff Setting : (deg) Date Installed : 2000-01-24T02:15Z Date Removed : (CCYY-MM-DDThh:mmZ) Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : This receiver is AC/DC 3.x Receiver Type : (A20, from rcvr_ant.tab; see instructions) Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : (A5) Firmware Version : (A11) Elevation Cutoff Setting : (deg) Date Installed : (CCYY-MM-DDThh:mmZ) Date Removed : (CCYY-MM-DDThh:mmZ) Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : (multiple lines) 4. GNSS Antenna Information 4.1 Antenna Type : AOAD/M_T Serial Number : 318 Antenna Reference Point : BPA Marker->ARP Up Ecc. (m) : 0.007 m Marker->ARP North Ecc(m) : (F8.4) Marker->ARP East Ecc(m) : (F8.4) Alignment from True N : Antenna Radome Type : DOME Radome Serial Number : Antenna Cable Type : (vendor & type number) Antenna Cable Length : (m) Date Installed : 1994-05-15 Date Removed : (CCYY-MM-DDThh:mmZ) Additional Information : 4.x Antenna Type : (A20, from rcvr_ant.tab; see instructions) Serial Number : (A*, but note the first A5 is used in SINEX) Antenna Reference Point : (BPA/BCR/XXX from "antenna.gra"; see instr.) Marker->ARP Up Ecc. (m) : (F8.4) Marker->ARP North Ecc(m) : (F8.4) Marker->ARP East Ecc(m) : (F8.4) Alignment from True N : (deg; + is clockwise/east) Antenna Radome Type : (A4 from rcvr_ant.tab; see instructions) Radome Serial Number : Antenna Cable Type : (vendor & type number) Antenna Cable Length : (m) Date Installed : (CCYY-MM-DDThh:mmZ) Date Removed : (CCYY-MM-DDThh:mmZ) Additional Information : (multiple lines) 5. Surveyed Local Ties 5.1 Tied Marker Name : RM1 Tied Marker Usage : (SLR/VLBI/LOCAL CONTROL/FOOTPRINT/etc) Tied Marker CDP Number : N/A Tied Marker DOMES Number : Differential Components from GNSS Marker to the tied monument (ITRS) dx (m) : -15.366 dy (m) : -9.632 dz (m) : 9.099 Accuracy (mm) : +-1mm Survey method : (GPS CAMPAIGN/TRILATERATION/TRIANGULATION/etc) Date Measured : 1992-08-12 Additional Information : (multiple lines) 5.2 Tied Marker Name : RM2 Tied Marker Usage : (SLR/VLBI/LOCAL CONTROL/FOOTPRINT/etc) Tied Marker CDP Number : N/A Tied Marker DOMES Number : Differential Components from GNSS Marker to the tied monument (ITRS) dx (m) : 6.890 dy (m) : -0.437 dz (m) : -9.874 Accuracy (mm) : +-1mm Survey method : (GPS CAMPAIGN/TRILATERATION/TRIANGULATION/etc) Date Measured : 1992-08-12 Additional Information : (multiple lines) 5.3 Tied Marker Name : RM3 Tied Marker Usage : (SLR/VLBI/LOCAL CONTROL/FOOTPRINT/etc) Tied Marker CDP Number : N/A Tied Marker DOMES Number : Differential Components from GNSS Marker to the tied monument (ITRS) dx (m) : 4.399 dy (m) : 15.434 dz (m) : 18.074 Accuracy (mm) : +-1mm Survey method : (GPS CAMPAIGN/TRILATERATION/TRIANGULATION/etc) Date Measured : 1992-08-12 Additional Information : (multiple lines) 5.x Tied Marker Name : Tied Marker Usage : (SLR/VLBI/LOCAL CONTROL/FOOTPRINT/etc) Tied Marker CDP Number : (A4) Tied Marker DOMES Number : (A9) Differential Components from GNSS Marker to the tied monument (ITRS) dx (m) : dy (m) : dz (m) : Accuracy (mm) : (mm) Survey method : (GPS CAMPAIGN/TRILATERATION/TRIANGULATION/etc) Date Measured : (CCYY-MM-DDThh:mmZ) Additional Information : (multiple lines) 6. Frequency Standard 6.1 Standard Type : QUARTZ/INTERNAL Input Frequency : Effective Dates : 1994-05-15/CCYY-MM-DD Notes : (multiple lines) 6.x Standard Type : Input Frequency : (if external) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 7. Collocation Information 7.x Instrumentation Type : (GPS/GLONASS/DORIS/PRARE/SLR/VLBI/TIME/etc) Status : (PERMANENT/MOBILE) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8. Meteorological Instrumentation 8.1.1 Humidity Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : Accuracy (% rel h) : (% rel h) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.1.x Humidity Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : (sec) Accuracy (% rel h) : (% rel h) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.2.1 Pressure Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : Accuracy : (mbar) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.2.x Pressure Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : (sec) Accuracy : (hPa) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.3.1 Temp. Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : Accuracy : (deg C) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.3.x Temp. Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : (sec) Accuracy : (hPa) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.4.1 Water Vapor Radiometer : Manufacturer : Serial Number : Distance to Antenna : (m) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.4.x Water Vapor Radiometer : Manufacturer : Serial Number : Distance to Antenna : (m) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.5.1 Other Instrumentation : (multiple lines) 8.5.x Other Instrumentation : 9. Local Ongoing Conditions Possibly Affecting Computed Position 9.1.x Radio Interferences : (TV/CELL PHONE ANTENNA/RADAR/etc) Observed Degredations : (SN RATIO/DATA GAPS/etc) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Additional Information : (multiple lines) 9.2.x Multipath Sources : (METAL ROOF/DOME/VLBI ANTENNA/etc) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Additional Information : (multiple lines) 9.3.x Signal Obstructions : (TREES/BUILDLINGS/etc) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Additional Information : (multiple lines) 10. Local Episodic Effects Possibly Affecting Data Quality 10.x Date : (CCYY-MM-DD/CCYY-MM-DD) Event : (TREE CLEARING/CONSTRUCTION/etc) 11. On-Site, Point of Contact Agency Information Agency : Geoscience Australia : Preferred Abbreviation : (A10) Mailing Address : Geoscience Australia Primary Contact Contact Name : Bob Twilley Telephone (primary) : +61 2 62014346 Telephone (secondary) : 0413 604180 (mobile) Fax : +61 2 62014366 E-mail : bobtwilley@auslig.gov.au Secondary Contact Contact Name : Paul Digney Telephone (primary) : +61 2 62014369 Telephone (secondary) : Fax : +61 2 62014366 E-mail : pauldigney@auslig.gov.au Additional Information : (multiple lines) 12. Responsible Agency (if different from 11.) Agency : (multiple lines) Preferred Abbreviation : (A10) Mailing Address : (multiple lines) Primary Contact Contact Name : Telephone (primary) : Telephone (secondary) : Fax : E-mail : Secondary Contact Contact Name : Telephone (primary) : Telephone (secondary) : Fax : E-mail : Additional Information : (multiple lines) 13. More Information URL for More Information : Hardcopy on File Site Map : (Y or URL) Site Diagram : Y Horizon Mask : Y Monument Description : Y Site Pictures : Y Additional Information : (multiple lines) Antenna Graphics with Dimensions Please insert here the character graphics corresponding to the antenna type. Check, complete or change if necessary the antenna dimensions. TurboRogue: DORNE MARGOLIN T ----- / + \ <-- 0.128 L2 | + | <-- 0.110 L1 +--------------------------------------------------+ <-- 0.102 TCR | | | | | | | | +-+--------------------------------------------------+-+ <-- 0.038 +-------------------+-------------+--------------------+ <-- 0.035 BCR | | 3D| | +------x------+ <-- 0.000 ARP <-- 0.381 --> ARP: Antenna Reference Point BPA: Bottom of Preamplifier