International GPS Service LIND Site Information Form See Instructions at: ftp://igscb.jpl.nasa.gov/pub/station/general/sitelog_instr.txt 0. Form Prepared by (full name) : Andrew Miner (contact) Date Prepared : 2002-04-25 Report Type : DYNAMIC If Update: Previous Site Log : lind0204.log Modified/Added Sections : (n.n,n.n,...) 1. Site Identification of the GNSS Monument Site Name : Lind Hall Four Character ID : LIND Monument Inscription : IERS DOMES Number : 49767M001 CDP Number : (A4) Monument Description : (PILLAR/BRASS PLATE/STEEL MAST/etc) Height of the Monument : (m) Monument Foundation : (STEEL RODS, CONCRETE BLOCK, ROOF, etc) Foundation Depth : (m) Marker Description : (CHISELLED CROSS/DIVOT/BRASS NAIL/etc) Date Installed : 1998-07-26T00:00Z Geologic Characteristic : Installed on top of 3-story brick building. Bedrock Type : (IGNEOUS/METAMORPHIC/SEDIMENTARY) Bedrock Condition : (FRESH/JOINTED/WEATHERED) Fracture Spacing : (1-10 cm/10-50 cm/50-200 cm/over 200 cm) Fault zones nearby : (YES/NO/Name of the zone) Distance/activity : (multiple lines) Additional Information : Building is constructed on Plio/Pleistocene : alluvial fan gravels, which form the upper : part of the thick Tertiary fill of the : Kittitas-Domerie syncline : Old monument (07/26/1998-04/04/2002) was a : 20cm threaded rod anchored to parapet of : interior, load bearing wall (brick with stone : cap), and extending about 3cm above surface. : New monument (effective 4/23/2002) was : constructed by coupling old rod to an : additional 14" length of 5/8" galvanized : threaded rod , anchoring 4 pieces of : epoxy-coated rebar in the wall, and pouring a : 6x6" pillar of grout made with concrete : adhesive around the lot. The rod projects : slightly as before and has a divot in the end : (the new mark). The antenna adaptor is a : UNAVCO leveling mount with a spike that rests : in the divot. The antenna threads onto a brass : rod/baseplate set in the spike/leveling mount. : Spike height to baseplate/antenna base is : 0.07931m 2. Site Location Information City or Town : Ellensburg State or Province : Washington Country : USA Tectonic Plate : North America Approximate Position (ITRF) X coordinate (m) : -2214365.82 Y coordinate (m) : -3753477.5 Z coordinate (m) : 4642135. Latitude (N is +) : +470000.00 Longitude (E is +) : -1203224.00 Elevation (m,ellips.) : 471.98 Additional Information : ITRF96 POSITION (EPOCH 1997.0) Computed in : Sep. 1998 using 16 days of data. : Kittitas County. : Reference frame used is (N/A). : Coordinate system used is (N/A). 3. GNSS Receiver Information 3.1 Receiver Type : TRIMBLE 4000SSI Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : 3626A 16331 Firmware Version : NP 7.26; SP 3.07 Elevation Cutoff Setting : (deg) Date Installed : 1998-07-26T00:00Z Date Removed : 1999-08-06T00:00Z Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : (multiple lines) 3.2 Receiver Type : TRIMBLE 4000SSI Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : 3626A 16331 Firmware Version : NP 7.29; SP 3.07 Elevation Cutoff Setting : (deg) Date Installed : 1999-08-06T00:00Z Date Removed : 1999-09-24T00:00Z Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : Firmware update 3.3 Receiver Type : TRIMBLE 4700 Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : 2201 61036 Firmware Version : NP 1.13; SP 1.31 Elevation Cutoff Setting : (deg) Date Installed : 1999-09-24T00:00Z Date Removed : 1999-09-28T00:00Z Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : Testing Trimble 4700 receiver 3.4 Receiver Type : TRIMBLE 4000SSI Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : 3626A 16331 Firmware Version : NP 7.29; SP 3.07 Elevation Cutoff Setting : (deg) Date Installed : 1999-09-28T00:00Z Date Removed : 2000-06-12T00:00Z Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : Test complete, original receiver installed 3.5 Receiver Type : TRIMBLE 4000SSI Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : 3626A 16331 Firmware Version : NP 7.19a; SP 3.07 Elevation Cutoff Setting : (deg) Date Installed : 2000-06-12T00:00Z Date Removed : 2000-12-22T00:00Z Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : firmware update 3.6 Receiver Type : TRIMBLE 4000SSI Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : 3610A 14856 Firmware Version : NP 7.29; SP 3.07 Elevation Cutoff Setting : (deg) Date Installed : 2000-12-22T00:00Z Date Removed : 2000-12-29T00:00Z Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : testing receiver removed from BURN 3.7 Receiver Type : TRIMBLE 4000SSI Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : 3626A 16331 Firmware Version : NP 7.19a; SP 3.07 Elevation Cutoff Setting : (deg) Date Installed : 2000-12-29T00:00Z Date Removed : (CCYY-MM-DDThh:mmZ) Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : original receiver installed after test 3.x Receiver Type : (A20, from rcvr_ant.tab; see instructions) Satellite System : (GPS/GLONASS/GPS+GLONASS) Serial Number : (A5) Firmware Version : (A11) Elevation Cutoff Setting : (deg) Date Installed : (CCYY-MM-DDThh:mmZ) Date Removed : (CCYY-MM-DDThh:mmZ) Temperature Stabiliz. : (none or tolerance in degrees C) Additional Information : (multiple lines) 4. GNSS Antenna Information 4.1 Antenna Type : TRM29659.00 Serial Number : 0220066919 Antenna Reference Point : BPA Marker->ARP Up Ecc. (m) : 0.0795 Marker->ARP North Ecc(m) : (F8.4) Marker->ARP East Ecc(m) : (F8.4) Alignment from True N : 0 Antenna Radome Type : NONE Radome Serial Number : Antenna Cable Type : (vendor & type number) Antenna Cable Length : (m) Date Installed : 1998-07-26T00:00Z Date Removed : (CCYY-MM-DDThh:mmZ) Additional Information : 4.x Antenna Type : (A20, from rcvr_ant.tab; see instructions) Serial Number : (A*, but note the first A5 is used in SINEX) Antenna Reference Point : (BPA/BCR/XXX from "antenna.gra"; see instr.) Marker->ARP Up Ecc. (m) : (F8.4) Marker->ARP North Ecc(m) : (F8.4) Marker->ARP East Ecc(m) : (F8.4) Alignment from True N : (deg; + is clockwise/east) Antenna Radome Type : (A4 from rcvr_ant.tab; see instructions) Radome Serial Number : Antenna Cable Type : (vendor & type number) Antenna Cable Length : (m) Date Installed : (CCYY-MM-DDThh:mmZ) Date Removed : (CCYY-MM-DDThh:mmZ) Additional Information : (multiple lines) 5. Surveyed Local Ties 5.x Tied Marker Name : Tied Marker Usage : (SLR/VLBI/LOCAL CONTROL/FOOTPRINT/etc) Tied Marker CDP Number : (A4) Tied Marker DOMES Number : (A9) Differential Components from GNSS Marker to the tied monument (ITRS) dx (m) : dy (m) : dz (m) : Accuracy (mm) : (mm) Survey method : (GPS CAMPAIGN/TRILATERATION/TRIANGULATION/etc) Date Measured : (CCYY-MM-DDThh:mmZ) Additional Information : (multiple lines) 6. Frequency Standard 6.x Standard Type : (INTERNAL or EXTERNAL H-MASER/CESIUM/etc) Input Frequency : (if external) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 7. Collocation Information 7.x Instrumentation Type : (GPS/GLONASS/DORIS/PRARE/SLR/VLBI/TIME/etc) Status : (PERMANENT/MOBILE) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8. Meteorological Instrumentation 8.1.1 Humidity Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : Accuracy (% rel h) : (% rel h) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.1.x Humidity Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : (sec) Accuracy (% rel h) : (% rel h) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.2.1 Pressure Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : Accuracy : (mbar) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.2.x Pressure Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : (sec) Accuracy : (hPa) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.3.1 Temp. Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : Accuracy : (deg C) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.3.x Temp. Sensor Model : Manufacturer : Serial Number : Data Sampling Interval : (sec) Accuracy : (hPa) Aspiration : (UNASPIRATED/NATURAL/FAN/etc) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.4.1 Water Vapor Radiometer : Manufacturer : Serial Number : Distance to Antenna : (m) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : CCYY-MM-DD/CCYY-MM-DD Notes : (multiple lines) 8.4.x Water Vapor Radiometer : Manufacturer : Serial Number : Distance to Antenna : (m) Height Diff to Ant : (m) Calibration date : (CCYY-MM-DD) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Notes : (multiple lines) 8.5.1 Other Instrumentation : 8.5.x Other Instrumentation : 9. Local Ongoing Conditions Possibly Affecting Computed Position 9.1.x Radio Interferences : (TV/CELL PHONE ANTENNA/RADAR/etc) Observed Degredations : (SN RATIO/DATA GAPS/etc) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Additional Information : (multiple lines) 9.2.x Multipath Sources : (METAL ROOF/DOME/VLBI ANTENNA/etc) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Additional Information : (multiple lines) 9.3.x Signal Obstructions : (TREES/BUILDLINGS/etc) Effective Dates : (CCYY-MM-DD/CCYY-MM-DD) Additional Information : (multiple lines) 10. Local Episodic Effects Possibly Affecting Data Quality 10.x Date : (CCYY-MM-DD/CCYY-MM-DD) Event : (TREE CLEARING/CONSTRUCTION/etc) 11. On-Site, Point of Contact Agency Information Agency : PANGA Preferred Abbreviation : (A10) Mailing Address : Department of Geology : Central Washington University : Ellensburg, WA 98926 : USA Primary Contact Contact Name : Meghan Miller Telephone (primary) : 509-963-2825 Telephone (secondary) : Fax : 509-963-2821 E-mail : meghan@geology.cwu.edu Secondary Contact Contact Name : Daniel J. Johnson Telephone (primary) : 509-963-2822 Telephone (secondary) : Fax : 509-963-2821 E-mail : dan@geology.cwu.edu Additional Information : (multiple lines) 12. Responsible Agency (if different from 11.) Agency : (multiple lines) Preferred Abbreviation : (A10) Mailing Address : (multiple lines) Primary Contact Contact Name : Telephone (primary) : Telephone (secondary) : Fax : E-mail : Secondary Contact Contact Name : Telephone (primary) : Telephone (secondary) : Fax : E-mail : Additional Information : (multiple lines) 13. More Information Primary Data Center : Secondary Data Center : URL for More Information : Hardcopy on File Site Map : (Y or URL) Site Diagram : (Y) Horizon Mask : (Y) Monument Description : (Y) Site Pictures : (Y) Additional Information : (multiple lines) Antenna Graphics with Dimensions (insert text graphic)